CAT 772G
税別価格
金額応相談
19
お気に入り
シェア
検索結果を保存印刷
情報
機械カテゴリー
リジットフレーム式ダンプトラック
メーカー／型式
CAT 772G
製造年
2017
使用時間数
9930 時間
機械の所在地
London, Ontario
国
カナダ
マスカス ID
2574F853
詳細
登録番号
T2873
その他情報
CAT 772G
Caterpillar 772 Rock Truck
CAT C18 ACERT Engine
Automatic 7 Speed Transmission
Cab (ROPS) w/ A/C
Supplemental Steering
Cold Weather Arrangement
Oil Immersed Disc Brakes
Extended Life Brakes
51 Ton/41 CYD Capacity
Truck Payload Management System
Flat Floor Body
21.00R33 Tires
Rear Michelin X-Tra Load Grip L4 Tires
Automatic Retarding Control
Cab Air Pre-Cleaner
Heated Side Mirrors
Rear View Camera
Fuel Heater
Wheel Chocks
Central Lubrication
Rated at 598 HP
Weight 80,000 LBS
A CAT 772 with a Flat Floor Steel Lined Bed, Body Side Boards, Heated Body, 21.00R33 Tires, Espar Heater, CAT Auto Greaser, Rear Camera, Truck Payload Management System, CAT Dealer Inspected, All Needed Repairs & Servicing Completed.
When unit arrived in yard, MEL had local CAT dealer complete the following:
Strip machine for power washing
CAT TA inspection
Update ECM flash files
Cut open all filters & inspect for contaminates - all clean
Service engine
Inspect magnetic plugs/screens & suction screens- all clean
Check oil levels
Inspect oils for discolouration
Check for logged & active codes & repair
Completed the following pressure checks to ensure within OEM spec:
Engine rpm high & low idle
Engine oil high & low idle pressures
Fuel pressure
Full stall boost
Full stall speed
Transmission pump pressure
Transmission lube pressure
Steering pressure check
Steering high pressure cut-off
Hoist relief pressure
Brake cut-in/cut-out pressure
Based on inspection, MEL completed the following repairs;
Installed NEW front brake pads & rotors
Installed NEW duo cone seal on front left wheel hub
REBUILT right rear brakes w/ all NEW plates & friction discs
Left rear brakes removed, cleaned, inspected & resealed
Installed NEW duo cone seal on rear wheel ends
Replaced all required brake hoses/lines
Installed NEW pins & bearings on rear suspension cylinders
Right rear suspension sensor broken – replaced sensor
Installed NEW transmission output shaft seal
Transmission filler joint coupler leaking – replaced coupling
Installed NEW oil drain line on turbo
Serviced DPF- field cleaned
Serviced emission system w/ NEW filter, DEF injector & spark plug
Replaced all required w/ NEW coolant lines
Installed NEW a/c compressor, accumulator & dryer
Replaced required hydraulic lines
Replaced required powertrain lines
Line bored rear box mount bores
Installed NEW box mount pins & bearings
Steering cylinders have play at barrel end - installed NEW tie rods
Line bored rear axle A-frame bore
Installed NEW pin & bearing in A-frame
Installed NEW pins & bearings in rear axle stay arm
Completed required cosmetic & welding repairs
Box bed was inspected & repaired as needed
Machine is ready to go to work.
もっと表示する
Marcel Equipment Limited
1000 Progress Drive N6N 1B8 London Ontario カナダ
12
マスカス利用歴（年）メール通知を受け取る
不審な掲載機械を報告